BigBoi D-IonizR GO DI Resin Water Filter Tank

Portable Deionised Water System for Spot-Free Results Anywhere

The BigBoi D-IonizR GO is a compact, portable single-stage deionised water filtration system designed for mobile detailers and enthusiasts who want spotless results without complex setup. Using advanced ion-exchange resin technology, it filters water to below 20 PPM, eliminating the minerals that cause water spots and streaks. Simply connect your garden hose and pressure washer and you're washing spot-free in minutes; no electricity required.

Why Our Customers Love the D-IonizR GO

✅ Eliminates water spots and streaks by filtering water to below 20 PPM.
✅ No electricity required; simply connect hose and pressure washer and go.
✅ Built-in bypass valve extends resin life by using filtration only when needed.
✅ TDS testing pen monitors incoming and outgoing water purity in real time.
✅ Filters approximately 1,900 litres (80-96 rinse cycles) per resin fill.

What Makes It Special?

Hard water is the enemy of a flawless finish. Minerals left behind after drying cause those stubborn spots that take longer to remove than the wash itself. The D-IonizR GO removes those minerals at source, giving you ultra-pure water that evaporates clean and leaves nothing behind. The bypass valve is the smart feature here; run tap water for the wash cycle and switch to filtered water only for the final rinse, dramatically extending your resin life.

• Single-stage deionising resin filters water to below 20 PPM.
• In-built bypass valve controls when filtration is active.
• Portable ergonomic carry handle for easy transport.
• Compatible with WashR FLO and WashR QUAD pressure washers.
• Filters approximately 1,900 litres per resin fill (100pm base in).
• Reduces drying time and eliminates towel-induced scratches.

Specifications

• Filtration Stages: Single stage (deionising resin).
• Water Purity: Filters to below 20 PPM.
• Recommended Flow Rate: 6.8 LPM (1.8 GPM).
• Maximum Flow Rate: 7.5 LPM (1.98 GPM).
• Dimensions: 60cmH x 24cmW x 24cmD.
• Weight: 13kg (full system with resin).
• Operating Temperature: Up to 40°C.
• Includes: D-IonizR GO unit, TDS testing pen, 2x resin bags, Teflon tape, fittings, spare O-rings, carry handle.
• Note: CR2032 battery for TDS tester not included.

Pro Tips From Ultimate Finish

"The bypass valve is the key to making your resin last. We run tap water through the wash cycle and only flip to filtered for the final rinse; your resin lasts dramatically longer this way and you still get the spot-free finish you're after. At 7.5 LPM max flow, this is matched to the WashR FLO and QUAD specifically; don't push it with higher-output machines or you'll reduce filter effectiveness."

How To Use

1. Fill unit with resin bags provided and secure all fittings with Teflon tape.
2. Connect garden hose to water inlet.
3. Connect outlet to WashR FLO or WashR QUAD pressure washer.
4. Use bypass valve for wash cycle to conserve resin life.
5. Switch to filtered mode for final rinse cycle.
6. Monitor outgoing TDS with included testing pen.
7. Replace resin when outgoing TDS reads 15 PPM or higher.

Important Notes

⚠️ Compatible with WashR FLO and WashR QUAD only; not recommended for WashR DUO or WashR PRO.
⚠️ Do not use with tank-fed water supplies.
⚠️ CR2032 battery for TDS tester not included.
⚠️ This product contains a button cell battery; keep out of reach of children. If swallowed, seek immediate medical attention.